B0013
DTC B0013
CIRCUIT DESCRIPTION
The body control module (BCM) uses the secondary serial data bus (circuit 1061) to poll the instrument cluster for information. DTC 13 will set if there is no instrument poll from the BCM for more than 10 seconds. In practice the trouble code is set somewhere between 10 and 20 seconds after the last instrument poll is received by the instrument cluster. The DTC is reset within 10 seconds of the arrival of an instrument poll from the BCM. The DTC is logged as a History DTC.
DIAGNOSTIC AIDS
By manipulating the harnesses at the various connectors it is often possible to isolate the cause of the circuit interruption. This harness can then be removed and repaired. Inspect for any damage to the harness which could cause an intermittent open or short to ground or backed out terminals at the instrument cluster connectors, broken connector locks, improperly formed or damaged terminals. The multimeter allows continuity of the wiring harness circuit 1061 to be checked. If the fault cannot be found in the harness then the fault may lie in the sensing and diagnostic module (SDM) or the BCM. Refer to Diagnostic Starting Point - Computer/Integrating Systems for further diagnosis. Testing and Inspection
TEST
Step 1 - Step 9:
DTC 13 - NO INSTRUMENT POLL FROM BCM