Procedures

DRIVER INFORMATION CENTER SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel cluster trim panel.
2. Remove the instrument panel center trim panel.
3. Remove the HVAC control assembly.
4. From the rear of the switch (3), squeeze the retaining clips (2) on each side of the switch (3) and push the switch (3) part way from the panel (4).
5. Using a plastic flat-bladed tool, hold the retaining clips (2) depressed while slowly removing the switch (3) from the panel (4).
6. Disconnect the wiring connector (1) and remove the switch (3) from the vehicle.

INSTALLATION PROCEDURE




1. Connect the wiring connector (1) to the switch (3).
2. Install the switch (3) to the panel (4), making sure the retaining clips (2) are engaged.
3. Install the HVAC control assembly.
4. Install the instrument panel center trim panel.
5. Install the instrument panel cluster trim panel (1).