Trim Plate Replacement - Console

Trim Plate Replacement - Console

Removal Procedure





1. Remove the console tray insert. Refer to Console Tray Insert Replacement (Removal and Replacement) .
2. Remove the screw (2) attaching the console trim plate (1) to the floor console.
3. Pull up on the console trim plate disconnecting the six retaining tabs.
4. Disconnect the power window switch and traction control switch connectors (3), if equipped.
5. Remove the power window switch. Refer to Power Window Switch Replacement (Service and Repair) in Doors.
6. Remove the traction control switch, if equipped. Refer to Traction Control Switch Replacement (Manual Transmission) Traction Control Switch Replacement (Automatic Transmission) in Antilock Brakes System.
7. Remove the cupholder. Refer to Cupholder Replacement - Front Floor Console (Service and Repair) .



Installation Procedure





1. Install the cupholder. Refer to Cupholder Replacement - Front Floor Console (Service and Repair) .
2. Install the traction control switch, if equipped. Refer to Traction Control Switch Replacement (Manual Transmission) Traction Control Switch Replacement (Automatic Transmission) in Antilock Brakes System.
3. Install the power window switch. Refer to Power Window Switch Replacement (Service and Repair) in Doors.
4. Connect the power window switch and traction control switch connectors (3).
5. Install the console trim plate (1) to the center console until the retaining tabs are engaged.

Notice: Refer to Fastener Notice in Cautions and Notices.

6. Install the screw (2) securing the console trim plate (1) to the center console.

Tighten the screw to 2 N.m (18 lb in).

7. Install the console tray insert. Refer to Console Tray Insert Replacement (Removal and Replacement) .