Bracket Replacement - Instrument Panel (I/P) End Right

BRACKET REPLACEMENT - INSTRUMENT PANEL (I/P) END RIGHT

REMOVAL PROCEDURE
1. Remove the instrument panel pad.
2. Remove the body control module.




3. Remove the screw (1) attaching the right end bracket assembly (2) to the lower radio bracket.
4. Remove the bolt (6) attaching the right end bracket assembly (2) to the lower radio bracket.
5. Remove the bolts (3) and (4) attaching the right end bracket assembly (2) to the vehicle.
6. Remove the two bolts (5) attaching the right end bracket (2) to the instrument panel inflatable restraint.
7. Detach the wiring harness and remove the right end bracket assembly (2) from the vehicle.

INSTALLATION PROCEDURE




1. Position the right end bracket assembly (2) to the vehicle and attach the wiring harness.
2. Install the 2 bolts (5) attaching the right end bracket (2) to the instrument panel inflatable restraint.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolts to 9 N.m (80 lb in).

3. Install the bolts (3) and (4) attaching the right end bracket assembly (2) to the vehicle.

Tighten the bolts to 9 N.m (80 lb in).

4. Install the bolt (6) attaching the right end bracket assembly (2) to the lower radio bracket.

Tighten the bolt to 9 N.m (80 lb in).

5. Install the screw (1) attaching the right end bracket assembly (2) to the lower radio bracket.

Tighten the screw to 2 N.m (18 lb in).

6. Install the body control module.
7. Install the instrument panel pad.