Instrument Panel (I/P) Extension Replacement

Instrument Panel (I/P) Extension Replacement

Removal Procedure





1. Remove the instrument panel compartment/ashtray. Refer to Ashtray Replacement (Service and Repair) .
2. Remove the left knee bolster trim panel, if necessary. Refer to Knee Bolster Replacement - Left (Removal and Replacement) .
3. Remove the three screws (1) attaching the instrument panel lower extension (2) to the instrument panel.
4. Remove the screw attaching the floor console front duct, if necessary.
5. Grip the top of the lower extension (2) and pull rearwards to release the retaining clip (5).
6. Disconnect the wiring connector (4) from the rear compartment release switch (3).
7. Remove the rear compartment release switch (3). Refer to Rear Compartment Lid Switch Replacement () in Body Rear End.



Installation Procedure





1. Install the rear compartment release switch (3). Refer to Rear Compartment Lid Switch Replacement () in Body Rear End.
2. Connect the wiring connector (4) to the rear compartment release switch (3).
3. Install the extension (2) to the instrument panel, making sure the retaining clip (5) is engaged.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the screw attaching the front floor console duct, if removed.

Tighten the screw to 2 N.m (18 lb in).

5. Install the three screws (1) attaching the lower extension (2) to the instrument panel.

Tighten the screws to 2 N.m (18 lb in).

6. Install the console trim plate. Refer to Trim Plate Replacement - Console (Removal and Replacement) .
7. Install the left knee bolster trim panel, if removed. Refer to Knee Bolster Replacement - Left (Removal and Replacement) .
8. Install the instrument panel compartment/ashtray. Refer to Ashtray Replacement (Service and Repair) .