Valve Guide Seal: Service and Repair

Valve Stem Oil Seal and Valve Spring Replacement

Tools Required
^ J22794 Spark Plug Port Adapter
^ J38606 Valve Spring Compressor (Head-on)

Removal Procedure
1. Remove the valve rocker arms.
2. Remove the spark plug.





3. Install the J22794 into the spark plug hole.
4. Attach an air hose to J22794.
5. Tap the end of the valve stem with a plastic face hammer in order to loosen any varnish on the valve stem keys.





6. Use the J38606 in order to compress the valve spring.





7. Remove the valve stem keys (1).
8. Carefully release the valve spring tension.
9. Remove the J38606.
10. Remove the valve spring cap (2).
11. Remove the valve spring (3).
12. Remove the valve stem oil seal and shim (4).

Installation Procedure





1. Clean the cylinder head valve spring seat and/or shim area.
2. Install the valve stem oil seal and shim (2).

3. Important: The valve stem oil seal alignment and position on the valve guide is critical.

An improperly installed valve stem oil seal may lead to excessive oil consumption and increased vehicle emissions.
Install the valve stem oil seal onto the guide.
1. Lubricate the valve guide and valve stem oil seal with clean engine oil.
2. Install the valve stem oil seal onto the valve stem. Push the seal down until the seal contacts the valve guide.





4. Install the valve spring to the J38606.
5. Compress the valve spring using the J38606.
6. Install the valve spring to the cylinder head.





7. Install the valve spring cap (2).
8. Install the valve stem keys (1).
1. Use grease to hold the keys (1) in place and remove J38606.
2. Make sure the keys (1) seat properly in the groove of the valve stem.
3. Carefully release the valve spring pressure, making sure the valve keys stay in place.
4. Remove the J38606.
5. Tap the end to the valve stem with a plastic faced hammer to seat the keys, if necessary.





9. Disconnect and remove the air supply from the J22794.
10. Remove the J22794 from the spark plug hole.





11. Measure the valve spring installed height using a ruler. Measure from the base of the valve spring to the top of the valve spring.
^ If the installed height exceeds 46.25 mm (1.82 inch), install a valve spring shim of approximately 0.5 mm (0.02 inch) thick.
^ Do not shim the valve spring to obtain less than the specified height. Do not assemble the components without a spring shim on the cylinder head.

12. Remove the air hose from the J22794.





13. Install the spark plug.
14. Install the valve rocker arms.