2. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Tools Required
^ J41816 Crankshaft Balancer Remover
^ J41816-2 Crankshaft End Protector
^ J42386-A Flywheel Holding Tool





1. Notice: Refer to Fastener Notice in Service Precautions.

Important: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.

Install the J42386-A and bolts. Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation.
Tighten the J42386-A bolts to 50 Nm (37 ft. lbs.).





2. Remove the crankshaft balancer bolt (139). Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.





3. Use the J41816 (1) and the J41816-2 (2) in order to remove the crankshaft balancer.





4. Remove the crankshaft balancer (138).
5. Remove the J42386-A and bolts.