Instrument Panel (I/P) Extension Replacement

INSTRUMENT PANEL (I/P) EXTENSION REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel compartment/ashtray.
2. Remove the left knee bolster trim panel, if necessary.
3. Remove the three screws (1) attaching the instrument panel lower extension (2) to the instrument panel.
4. Remove the screw attaching the floor console front duct, if necessary.
5. Grip the top of the lower extension (2) and pull rearwards to release the retaining clip (5).
6. Disconnect the wiring connector (4) from the rear compartment release switch (3).
7. Remove the rear compartment release switch (3).

INSTALLATION PROCEDURE




1. Install the rear compartment release switch (3).
2. Connect the wiring connector (4) to the rear compartment release switch (3).
3. Install the extension (2) to the instrument panel, making sure the retaining clip (5) is engaged.
4. Install the screw attaching the front floor console duct, if removed.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 2 N.m (18 lb in).

5. Install the three screws (1) attaching the lower extension (2) to the instrument panel.

Tighten the screws to 2 N.m (18 lb in).

6. Install the console trim plate.
7. Install the left knee bolster trim panel, if removed.
8. Install the instrument panel compartment/ashtray.