Dome Lamp: Service and Repair

DOME LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Remove the dome lamp lens (1) from the dome lamp bezel using a small flat bladed tool as a lever on the right side of the dome lamp lens.
2. Remove the two screws (2) securing the lamp assembly.
3. Pull the lamp assembly down and disconnect the wiring harness connector from the lamp assembly.

INSTALLATION PROCEDURE




1. Connect the wiring harness connector to the lamp assembly.
2. Position the lamp assembly to the headliner.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the two screws (2) securing the lamp assembly to the headliner.

Tighten the two screws to 2 N.m (18 lb in).

4. Install the dome lamp lens (1) to the dome lamp bezel.