Fog/Driving Lamp: Service and Repair

FOG LAMP REPLACEMENT - FRONT

REMOVAL PROCEDURE




1. Remove the front lower fascia grille.
2. From behind the front bumper fascia assembly, disconnect the fog lamp harness (2) from the main harness connector.
3. Remove the three nuts (4) securing the front fog lamp assembly (1) to the bumper bar fascia (5).
4. Remove the fog lamp assembly (1).

INSTALLATION PROCEDURE




1. Position the fog lamp assembly (1) to the front bumper bar fascia (5) and route harness (2) through access hole (3).
2. Ensure that the fog lamp assembly (1) is correctly orientated with the beam adjustment screw located to the top.
3. Ensure that the lamp is located on the fascia datum pins
4. Install the three front fog lamp nuts (4) to the fog lamp (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 2 N.m (18 lb in).

5. Check and adjust the front fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure.
6. Install the front bumper fascia lower grille.