Oil Level Sensor: Service and Repair

Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Drain the engine of oil.
3. Disconnect the electrical connector.
4. Remove the engine oil lever sensor.

Installation Procedure

1. Notice: Refer to Fastener Notice.

Install the drain plug.
Tighten the drain plug to 25 Nm (18 ft. lbs.).
2. Install the engine oil level sensor.
Tighten the drain plug to 20 Nm (15 ft. lbs.).
3. Reconnect the electrical connector.
4. Lower the vehicle.
5. Refill the engine. Refer to Capacities - Approximate Fluid.