Clutch Switch: Service and Repair

Clutch Pedal Position Switch Replacement
Removal Procedure
1. Disable the supplemental inflatable restraints (SIR) system.
2. Remove the left instrument panel (I/P) lower insulator panel.





3. Disconnect the clutch pedal position switch harness electrical connector (1) from the clutch pedal position switch (2).
4. Rotate the clutch pedal position switch (2) counterclockwise a quarter turn, then remove the switch from the pedal bracket assembly.

Installation Procedure





1. Install the switch in the pedal bracket assembly, then Rotate the clutch pedal start switch (2) clockwise a quarter turn to the locked position.
2. Connect the clutch pedal position switch electrical connector to the switch (2).
3. Install the instrument panel driver knee bolster.
4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.