Transmission Vent Tube Replacement

Transmission Vent Tube Replacement

Removal Procedure
1. Remove the transmission support bracket.
2. Remove the propeller shaft.
3. Lower the tail shaft of the transmission enough to access the transmission bolt (2).





4. Remove the transmission bolt (2).
5. Remove the vent tube (3) from the vent pipe.

Installation Procedure





1. Install the vent tube (3) to the vent pipe.

2. Notice:
Refer to Fastener Notice.

Install the transmission bolt (2).

Tighten the transmission bolt (2) to 50 Nm (37 ft. lbs.).

3. Raise the tail shaft of the transmission.
4. Install the propeller shaft.
5. Install the transmission mount.