Hood Latch Release Cable: Service and Repair

Hood Latch Release Cable Replacement

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover


Removal Procedure





1. Open the hood.
2. Remove the left front headlamp. Refer to Headlamp Assembly or Headlamp Bulb Replacement (GT).

Important: Block the hood latch in order to prevent the hood from locking until you have installed the hood latch release cable.


3. Remove the hood latch. Refer to Hood Latch Replacement (Service and Repair) .
Squeeze the cable retainer to remove the release from the hood latch.
4. Remove the front sheet metal diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal (Service and Repair) .
5. Remove the air cleaner. Refer to Air Cleaner Assembly Replacement.
6. Tie a wire or string to the end of the hood release cable. Ensure that the end of the wire or string remains in the engine compartment.




7. Remove the hood release cable retainers from the engine compartment side rail.
8. Remove the left front carpet retainer. Refer to Carpet Retainer Replacement - Front (Service and Repair) in Interior Trim.
9. Pull the carpet back to access the hood release.




10. Remove the hood release cable from the hood release handle.
11. Squeeze the tabs on the cable retainer to remove the cable assembly from the hood release handle assembly.




12. Use a small flat-bladed tool to remove the grommet from the dash panel.
13. Remove the hood latch release cable from the dash panel and vehicle.



Installation Procedure





1. Tie the hood latch release cable to a wire or string. Route the hood latch release cable grommet through the dash panel.
2. Apply strip caulk sealer or equivalent around the grommet.
3. Install the hood latch release cable to the hood release handle.
4. Install the cable assembly into the hood release handle assembly until you hear the tabs click.
5. Pull the carpet back.
6. Install the front left carpet retainer. Refer to Carpet Retainer Replacement - Front (Service and Repair) in Interior Trim.




7. Install the hood latch release cable retainers to the engine compartment side rail retainers.
8. Route the hood latch release cable through the radiator support.
9. Install the air cleaner. Refer to Air Cleaner Assembly Replacement.
10. Install the front sheet metal diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal (Service and Repair) .




11. Install the release cable to the hood latch.
12. Install the hood latch. Refer to Hood Latch Replacement (Service and Repair) .
13. Install the left front headlamp. Refer to Headlamp Assembly or Headlamp Bulb Replacement (GT).
14. Remove the block from the latch mechanism.
15. Inspect the hood latch for proper operation.
16. Close the hood.