Exhaust Crossover Pipe: Service and Repair

Exhaust Crossover Pipe Replacement (RPOs L26/L32)
Removal Procedure





1. Remove the fuel injector sight shield.
2. Remove the air cleaner intake duct.
3. Remove the exhaust crossover heat shield nuts (1).
4. Remove the exhaust crossover heat shield (2).





5. Remove the exhaust crossover pipe studs (3) and the bolts (2).
6. Remove the exhaust crossover pipe (1).
7. Remove the exhaust crossover pipe seal (4).

Installation Procedure





1. Install the exhaust crossover pipe seal (4) to the exhaust crossover pipe (1) at the right exhaust manifold connection.
2. Install the exhaust crossover pipe (1).

3. Install the exhaust crossover pipe studs (3) and the bolts (2).
Tighten the studs and the bolts to 20 Nm (15 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.






4. Install the exhaust crossover heat shield (2).
5. Install the exhaust crossover heat shield nuts (1).
Tighten the nuts to 20 Nm (15 ft. lbs.).
6. Install the air cleaner intake duct.
7. Install the fuel injector sight shield.