Instrument Panel Cluster (IPC) Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel (I/P) cluster trim plate.

IMPORTANT: The ignition switch must be in the OFF position when removing the instrument cluster.

2. Remove the instrument cluster screws.
3. Pull the instrument cluster towards you and disconnect the electrical connector.
4. Remove the instrument cluster.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the instrument cluster.
2. Align the instrument cluster to the I/P.
3. Install the instrument cluster screws.

NOTE: Refer to Fastener Notice.

Tighten the instrument cluster screws to 2 N.m (18 lb in).

4. Install the I/P cluster trim plate.
5. If a new instrument cluster was installed, program the cluster. Refer to Instrument Panel Cluster Programming and Setup.