73. Engine Front Cover Installation

Engine Front Cover Installation

^ Tools Required
- J 45059 Angle Meter





1. Install the engine front cover gasket.





2. Install the engine front cover.Align the cogs on the crankshaft sprocket with the cogs on the oil pump in the engine front cover.
3. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or the equivalent to the engine front cover bolt threads.

4. Install the engine front cover bolts.
Tighten the engine front cover bolts to 20 Nm (15 ft. lbs.). Use the J 45059 to tighten the engine front cover bolts an additional 40 degrees.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the oil filter.
Tighten the oil filter to 30 Nm (22 ft. lbs.).





6. Install the crankshaft position sensor.
Tighten the crankshaft position sensor studs to 30 Nm (22 ft. lbs.).





7. Install the crankshaft position sensor shield.