Fuel Tank Pressure Sensor: Service and Repair

FUEL TANK PRESSURE SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the rear compartment trim panel.
3. Remove the nuts from the fuel sender access panel.
4. Remove the fuel sender access panel.




5. Disconnect the fuel tank pressure sensor electrical connector.
6. Remove the fuel tank pressure sensor (7) from the fuel sender assembly (1).

INSTALLATION PROCEDURE




1. Install the new fuel tank pressure sensor (7) to the fuel sender assembly (1).
2. Connect the fuel tank pressure sensor electrical connector.




3. Install the fuel sender access panel.
4. Install the fuel sender access panel nuts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 10 N.m (89 lb in).

5. Install the rear compartment trim panel.
6. Connect the negative battery cable.