Side

INFLATABLE RESTRAINT SIDE IMPACT SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or to SIR Disabling and Enabling Zone 6.

CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

2. Place the window in the raised position to access the sensor.
3. Remove the door trim panel.
4. Remove enough of the water deflector to access the side impact sensor (1).
5. Loosen the bolts (2) on the inflatable restraint side impact sensor (1).
6. Remove the inflatable restraint side impact sensor (1) out from the door (4).




7. Remove the connector position assurance (CPA) (3) from the side impact sensor connector (4).
8. Disconnect the side impact sensor connector (4).
9. Remove the sensor from the vehicle.

INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Position the inflatable restraint side impact sensor by the door.




3. Connect the side impact sensor connector (4).
4. Install the CPA (3) to the side impact sensor connector (4).




5. Install the side impact sensor (1) to the door (4).
6. Align the locating pin on the sensor (1) to the opening in the door (4).Begin tightening the side impact sensor bolts (2).

Tighten the bolts to 10 N.m (89 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

7. Install the water deflector to the door.
8. Install the door trim panel.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 , or SIR Disabling and Enabling Zone 6.