2. Crankshaft Balancer Removal

Crankshaft Balancer Removal
^ Tools Required
- J 41816 Crankshaft Balancer Remover
- J 41816-2 Crankshaft End Protector
- EN 47699 Flywheel Holding Tool





1. Important: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.

Install the EN 47699 (2), spacer (1), and bolt (3) to the block and flywheel.





2. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the EN 47699 bolt (1).
^ Tighten the bolt to 60 Nm (44 ft. lbs.).





3. Remove the crankshaft balancer bolt (139). Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.





4. Use the J 41816 (1) and the J 41816-2 (2) in order to remove the crankshaft balancer.





5. Remove the crankshaft balancer (138).
6. Remove the EN 47699, bolt, and spacer.