74. Valve Lifter Installation

Valve Lifter Installation





1. Important:
^ When using the valve lifters again, install the lifters to their original locations.
^ If camshaft replacement is required, the valve lifters must also be replaced.
^ Each of the 4 valve guide assemblies will contain 2 displacement on demand valve lifters and 2 non-displacement on demand valve lifters.
^ With the lifters and guides properly installed, cylinders 1, 4, 6, and 7 lifter bores will each contain 2 displacement on demand valve lifters.

Lubricate the valve lifters (209, 219) and engine block valve lifter bores with clean engine oil.





2. Insert the valve lifters into the lifter guides.
^ Align the flat area (3) on the top of the non displacement on demand lifter with the flat area in the lifter guide bore. Push the lifter completely into the guide bore.
^ The displacement on demand lifters are to be installed into the guide, with the notch in the guide (1) aligned with the raised area (2) of the lifter.





3. Install the valve lifters and guide assembly (210) to the engine block.

4. Notice: Refer to Fastener Notice in Service Precautions.

Install the valve lifter guide bolts (211).
- Tighten the valve lifter guide bolts to 12 Nm (106 inch lbs.).