79. Valve Rocker Arm Cover Installation - Right Side

Valve Rocker Arm Cover Installation - Right





1. Important:
^ All gasket surfaces should be free of oil or other foreign material during assembly.
^ DO NOT use the valve rocker arm cover gasket again.
^ The valve rocker arm cover bolt grommets may be used again if not damaged.

Install a NEW gasket (504) into the valve rocker arm cover.





2. Install the valve rocker arm cover onto the cylinder head.

3. Notice: Refer to Fastener Notice in Service Precautions.

Install the cover bolts with grommets.
^ Tighten the valve rocker arm cover bolts to 12 Nm (106 inch lbs.).





4. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bolts (723).
5. Install the ignition coils (722), wire harness (721), and bolts (723) to the bracket (719).
^ Tighten the ignition coil bolts to 8 Nm (71 inch lbs.).





6. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bracket studs (720).
7. Install the ignition coil and bracket assembly (719) and studs (720).
^ Tighten the bracket studs to 12 Nm (106 inch lbs.).