61. Camshaft Cover Installation

Camshaft Cover Installation





1. Assemble the camshaft cover and NEW gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the cover on the cylinder head and hand start the bolts.
^ Tighten the camshaft cover bolts to 10 Nm (89 inch lbs.).





3. Install the front lift bracket and bolt.
^ Tighten the front lift bracket bolt to 25 Nm (18 ft. lbs.).





4. Install the rear lift bracket and bolts.
^ Tighten the rear lift bracket bolts to 25 Nm (18 ft. lbs.).





5. Install the ground strap and bolt.
^ Tighten the camshaft cover ground strap bolt to 10 Nm (89 inch lbs.).





6. Install the spark plugs.
^ Tighten the spark plugs to 20 Nm (15 ft. lbs.).





7. Install the ignition coil and module assembly to the cam cover.
8. Install the cam cover bolts.
^ Tighten the ignition coil and module assembly bolts to 10 Nm (89 inch lbs.).





9. Install the power steering pump and bolts.
^ Tighten the power steering pump bolts to 25 Nm (18 ft. lbs.).