Relay Box: Service and Repair

UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK BRACKET REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the cover (2) from the underhood electrical center.




3. Remove the underhood positive battery terminal lug (4).
4. Disconnect the positive battery cables (5) from the underhood electrical center.

IMPORTANT: Take note of the positioning of the positive battery cables before disconnecting the cables.

5. Loosen all of the underhood electrical bolts (3).

IMPORTANT: The underhood electrical center bolts (3) are retained in the electrical center.

6. Remove the underhood electrical center (1) from the vehicle.

INSTALLATION PROCEDURE




1. Position the underhood electrical center (1) to the vehicle.
2. Tighten the underhood electrical bolts to 10 N.m (89 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the positive battery cables (5) to the underhood electrical center.
4. Install the underhood positive battery terminal lug (4).

Tighten the terminal lug to 15 N.m (133 lb in).

5. Install the cover (2) to the underhood electrical center.
6. Connect the negative battery cable.