66. Intake Manifold Installation

Intake Manifold Installation





1. Notice: Refer to Fastener Notice in Service Precautions.

Install the intake manifold studs in the manifold face.
Tighten the intake manifold studs to 6 Nm (53 inch lbs.).





2. Install a new intake manifold gasket on the intake manifold.
3. Install the intake manifold.
4. Install the intake manifold bolts and nuts.
Tighten the bolts and nuts to 10 Nm (89 inch lbs.).





5. Lubricate the fuel injector tip insulators with engine oil.
6. Install new fuel injector tip insulators.





7. Lubricate the fuel injector oil rings with engine oil.
8. Install the fuel rail assembly.
9. Install the fuel rail bolts.
Tighten the bolts to 10 Nm (89 inch lbs.).





10. Install a new throttle body gasket.
11. Install the throttle body.
Tighten the bolts and nuts to 10 Nm (89 inch lbs.).





12. Important: Ensure that the rear metal tab of the EVAP emission canister valve is resting on the power steering pump metal body.

Install the EVAP emission canister valve (2).
Tighten the EVAP canister valve bolt to 22 Nm (16 ft. lbs.).
13. Install the EVAP emission canister valve tube (1).