License Lamps Inoperative

LICENSE LAMPS INOPERATIVE




DIAGNOSTIC FAULT INFORMATION

IMPORTANT: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Testing and Inspection

CIRCUIT/SYSTEM DESCRIPTION
Battery voltage is applied at all times to the coil and switch sides of the PARK LAMP Relay located in the underhood fuse block. Ground is applied at G201 to the turn signal/multifunction switch at all times. When the headlamp switch is placed in either the HEAD or PARK position, ground is applied to the park lamp switch signal circuit to the body control module (BCM). The BCM reacts to the signal from the park lamp switch by applying ground to the park lamp relay control circuit. This energizes the PARK LAMP Relay and applies battery voltage to the PARK LPS fuse. Voltage flows through the PARK LPS fuse to all park, tail, license, and side marker lamps. Ground for the front park and side marker lamps is supplied at G101 for the left and G102 for the right. Ground for the license and right rear tail lamps is supplied at G402, and the left rear tail lamps at G400.

CIRCUIT/SYSTEM TESTING
1. Ignition OFF, disconnect the license lamp harness connector.
2. Connect a test lamp between the license lamp supply voltage circuit and ground.
3. Ignition ON, turn ON the park lamps. The test lamp should illuminate.
- If the test lamp does not illuminate, repair the license lamp voltage supply circuit for a short to ground or an open/high resistance.
4. Verify that a test lamp illuminates between battery voltage and the license lamp ground circuit.
- If the test lamp does not illuminate, repair the license lamp ground circuit for an open/high resistance.
5. If all circuits test normal, replace the license lamp.

REPAIR INSTRUCTIONS

IMPORTANT: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

License Lamp Bulb Replacement