P0121
DTC P0121
CIRCUIT DESCRIPTION
The DTC P0121 Throttle Position (TP) Sensor Performance diagnostic monitors the sensor activity. The TP sensor is a potentiometer whose resistance value changes along with the throttle valve position. The powertrain control module (PCM) provides a 5-Volt reference voltage to the TP sensor. The PCM reads the voltage across the TP sensor and uses the voltage to calculate the percentage of throttle valve opening. The TP sensor resistance decreases as the throttle valve opening increases. When the TP sensor resistance decreases the voltage being monitored by the PCM increases. The TP sensor resistance increases when the throttle valve opening decreases, therefore the voltage being monitored by the PCM will decrease.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC P0121 Throttle Position (TP) Sensor Performance
CONDITIONS FOR RUNNING THE DTC
- The engine speed is increasing.
- The engine is operating in Closed Loop.
- DTC P0121 runs once per drive cycle when the above conditions have been met.
CONDITIONS FOR SETTING THE DTC
The throttle position (TP) sensor voltage is fixed or out of the applicable range.
ACTION TAKEN WHEN THE DTC SETS
- The PCM illuminates the malfunction indicator lamp (MIL) during the second key cycle in which the diagnostic trouble code (DTC) sets.
- The PCM stores the conditions which were present when the DTC set as Freeze Frame data.
CONDITIONS FOR CLEARING THE MIL/DTC
- The PCM turns OFF the MIL on the third consecutive trip cycle during which the diagnostic has been run and the fault condition is no longer present.
- A DTC clears after 40 consecutive warm-up cycles have occurred without a fault.
- A DTC can be cleared by using the scan tool Clear DTC Information function.
DIAGNOSTIC AIDS
Inspect the throttle valve linkage and lever assembly for free and normal movement. Binding or misalignment of the throttle valve can affect the TP sensor input. Check that the throttle lever has not been bent or tampered with. Check that the throttle valve opens fully, and the lever contacts the throttle stop.
On a good TP sensor the scan tool will typically display a TP angle of 8-10 percent at idle, and 76-77 percent at wide open throttle (WOT).
An intermittent malfunction may be caused by fault in the TP sensor electrical circuit. Inspect the wiring harness and the components for an intermittent condition.
Repair any electrical circuit faults that were found.
The information included in the Freeze Frame data can be useful in determining the vehicle operating conditions when the DTC first set.
TEST DESCRIPTION
Step 1 - Step 10:
Step 11 - Step 13:
The numbers below refer to the step numbers on the diagnostic table.
1. The Diagnostic System Check - Vehicle prompts the technician to complete some basic checks and store the Freeze Frame data on the scan tool, if applicable. This creates an electronic copy of the data taken when the fault occurred. The information is then stored in the scan tool for later reference.
2. The throttle angle percentage should steadily increase without binding or a large percentage jump.
3. This step determines if DTC P0121 is the result of a hard failure or an intermittent condition.
4. This step inspects for an open or a short in the FTP sensor 5-Volt reference.
5. This step inspects for excessive resistance in the reference voltage circuit. If the test lamp does not illuminate at all, there is resistance in the circuit.
7. When the 5-Volt reference circuit is jumpered to the TP sensor input circuit, the scan tool parameter should read near 100 percent.