Trim Panel Replacement - Upper Center Pillar

TRIM PANEL REPLACEMENT - UPPER CENTER PILLAR

REMOVAL PROCEDURE




1. Disable the SIR System. Refer to SIR Disabling and Enabling Zones in Restraint Systems.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the front side door sill trim plate.
3. Remove the rear door sill trim plate.
4. Remove the center pillar lower trim panel.
5. Remove the seat shoulder belt guide adjuster (1) trim cover and the bolt.
6. Position the belt (2) on the floor.




7. Remove the center pillar upper trim panel (2) by gently pulling loose.

INSTALLATION PROCEDURE




1. Install the center pillar upper trim panel (2), by pushing in until tab (1) fastens.




2. Install the seat shoulder belt guide adjuster (1) bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the adjuster bolt to 42 N.m (31 lb ft).

3. Install the seat shoulder belt guide trim cover.
4. Install the center pillar lower trim panel.




5. Install the front side door sill trim plate (1) to the vehicle.
6. Install the rear side door sill trim plate.
7. Enable the SIR System. Refer to SIR Disabling and Enabling Zones in Restraint Systems.