Master Cylinder Reservoir Replacement

Master Cylinder Reservoir Replacement

Removal Procedure
1. Clean the outside of the brake master cylinder reservoir and the reservoir cap (4).
2. Disconnect the brake fluid level switch connector (5).
3. Remove the reservoir cap.
4. Remove the reservoir diaphragm.

Caution: Refer to Brake Fluid Important Caution in Cautions and Notices.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.

5. Remove the brake fluid with the syringe.
6. If the vehicle has a manual transmission, loosen the hose clamp (7) and remove the clutch hose (8) from the reservoir.
7. Remove the screw that retains the reservoir to the master cylinder (5).
8. Remove the reservoir and the grommets from the master cylinder (4,7).

Installation Procedure

Caution: Refer to Brake Fluid Caution in Cautions and Notices.

Notice: Refer to Filling the Master Cylinder Notice in Cautions and Notices.

1. Lubricate the grommets (4,7) with new brake fluid.
2. Install the grommets to the master cylinder.
3. Install the reservoir to the master cylinder.
4. Install the screw (5).
5. Install the reservoir diaphragm (2).
6. Fill the reservoir and install the cap. Refer to Master Cylinder Reservoir Filling. Master Cylinder Reservoir Filling
7. Inspect the master cylinder for fluid leakage.
8. Connect the brake fluid level switch connector.