Rear Suspension

Stabilizer Shaft Link Replacement

Removal Procedure





1. Remove the 2 nuts (2,4) from the link studs.
2. Remove the link from the knuckle.
3. Remove the link from the stabilizer shaft.

Installation Procedure





1. Install the link (1) to the stabilizer shaft (3).
2. Install the link to the knuckle.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the 2 nuts (2,4) to the link studs.
^ Tighten the nuts to 44 Nm (32.5 ft. lbs.).