Tire Pressure Monitor Procedure

TIRE PRESSURE MONITOR RESET PROCEDURE

IMPORTANT: After resetting, the tire pressure monitoring (TPM) system requires 60 minutes or more of driving at a speed of 30 km/h (19 mph) or above to complete the calibration process to have full capability for detecting a tire pressure condition. For further information, refer to Tire Pressure Monitor Description and Operation.

1. Adjust all tire pressures to the recommended kPa/psi.
2. Turn "ON" the ignition, with the engine OFF.
3. Press and hold the tire pressure warning "reset" switch until the tire pressure warning indicator blinks 3 times at one second intervals.
4. If the tire pressure warning indicator does not blink, repeat the procedure starting at step 2.
5. Drive the vehicle for 60 minutes or more at a speed of 30 km/h (19 mph).
6. Verify the system has initialized. Turn "ON" the ignition, with the engine "OFF" and observe the tire pressure warning indicator.
^ System Initialized: light on for 3 seconds.
^ System not initialized: light on for 4 seconds.