MU5

Repair Instructions



Manual Selector Replacement
Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Remove the center instrument trim panel.
3. Remove the instrument compartment.
4. Remove the front floor console.





5. Push in the retaining clip, then disconnect the cable from the shifter assembly.





6. Using a screwdriver, disconnect the park lock cable from the bracket.





7. Disconnect the shift select cable from the manual selector lever.





8. Using a screwdriver, disconnect the shift select cable from the shift lever plate.





9. Disconnect the electrical connectors, then the wire harness clip.





10. Remove the 4 nuts, then the manual selector from the vehicle.

Installation Procedure





Notice: Refer to Fastener Notice in Service Precautions.

1. Install the manual selector into the vehicle. Secure the manual selector with 4 nuts.
^ Tighten the manual selector bolts to 12 Nm (12 ft. lbs.).





2. Connect the manual selector electrical connectors.





3. Install the shift select cable into the shift lever plate.





4. Connect the shift select cable to the manual selector lever.





5. Install the park lock cable to the shift lever plate.





6. Connect the park lock cable to the manual selector lever.
7. Install the center instrument trim panel.
8. Install the instrument compartment.
9. Install the front floor console.
10. Connect the negative battery cable.