Clutch Master Cylinder: Service and Repair

Clutch Master Cylinder Replacement

Removal Procedure





1. Remove the brake booster assembly from the vehicle. Refer to Hydraulic Clutch Bleeding in Hydraulic Brakes.
2. Disconnect the clutch reservoir tube from the clutch master cylinder assembly.





3. Disconnect the pipe from the clutch master cylinder.





4. Remove the clutch master cylinder push rod clevis pin and clip.





5. Remove the 2 clutch master cylinder retaining nuts.
6. Remove the clutch master cylinder from the vehicle.

Installation Procedure
1. Install the clutch master cylinder in the vehicle.





2. Notice: Refer to Fastener Notice in Cautions and Notices.

Install the clutch master cylinder retaining nuts.
Tighten the clutch master cylinder retaining nuts to 12 Nm (9 ft. lbs.).





3. Install the clevis pin and clip.





4. Install the hydraulic pipe to the clutch master cylinder.
5. Install the brake booster assembly in the vehicle. Refer to Hydraulic Clutch Bleeding in Hydraulic Brakes.





6. Connect the reservoir tube to the clutch master cylinder.
7. Bleed the clutch. Refer to Vacuum Brake Booster Replacement