Clutch Pedal Position Switch Replacement

Clutch Pedal Position Switch Replacement

^ Tools Required
- J 39200 Digital Multimeter

Removal Procedure

1. Caution: Refer to Battery Disconnect Caution in Cautions and Notices.

Disconnect the negative battery cable.





2. Disconnect the electrical connector from the CPP switch.
3. Remove the CPP switch from the clutch and the brake pedal bracket by turning the CPP switch counterclockwise.
4. Remove the CPP switch lock nut from the CPP switch.
5. Inspect the CPP switch for excessive wear or damage. Replace the switch as necessary.

Installation Procedure
1. Install the CPP switch lock nut to the CPP switch.
2. Install the CPP switch into the clutch and the brake pedal bracket by turning the CPP switch clockwise.
3. Use the J 39200 in order to adjust the clutch pedal position CPP switch.





4. Depress the clutch pedal (2) to the floor (3). Return the clutch pedal within 15 - 30 mm (0.6 - 1.2 inch) from the floor.





5. Adjust the probes of J 39200 in contact with both leads of the CPP switch electrical connector (2).

6. Notice: Refer to Fastener Notice in Cautions and Notices.

Adjust the CPP switch by threading the switch into the clutch and the brake pedal bracket until the continuity is achieved.
Tighten the CPP switch lock nut to 13 Nm (115 inch lbs.).
7. Connect the electrical connector to the CPP switch.
8. Connect the negative battery cable.