Front Door Window Glass: Service and Repair

Window Replacement - Front Door

Removal Procedure





1. Remove the front side door water deflector. Refer to Water Deflector Replacement - Front Door (Service and Repair) .
2. Remove the 3 screws (1) and the access shield (2) from the door (3), if equipped.




3. Remove the 2 window-to-regulator bolts (2).
4. Remove the window (1) by pulling up and out of the door.



Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.


Important: Before installing the window into the door, check to see that the bottom channels are securely attached to the window. If a channel is loose, note the location of the channel on the window and then remove the channel from the window. Clean all remaining adhesive from the channel. Apply a bead of Automix Channel Bonding and Sidelite Adhesive, 3M P/N 08641, or equivalent, to the channel and install the channel onto the window. Refer to adhesive manufacturer's instructions for cure time.


1. Install the window (1) to the door. Secure the window to the regulator with 2 bolts (2).

Tighten the window-to-regulator bolts to 8 N.m (71 lb in).





2. Install the access shield (2) to the door (3), if equipped. Secure the shield with the 3 screws (1).
3. Install the front side door water deflector. Refer to Water Deflector Replacement - Front Door (Service and Repair) .