Antenna Module Coil Replacement

ANTENNA MODULE COIL REPLACEMENT

REMOVAL PROCEDURE




1. Remove the left rear quarter upper trim panel.
2. Disconnect the radio antenna module coil connector at the glass.
3. Remove the radio antenna module coil bolt.




4. Disengage the tab on the module from the opening. Remove the radio antenna module coil.

INSTALLATION PROCEDURE




1. Insert the tab on the module to the opening.




2. Install the radio antenna module coil bolt.

Tighten the bolt to 6 N.m (53 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the radio antenna module coil connector at the glass.
4. Install the left rear quarter upper trim panel.