Low Tire Pressure Indicator Flashes

Low Tire Pressure Indicator Flashes

Circuit Description
The electronic brake control module (EBCM) turns ON the tire pressure warning indicator by opening the tire pressure warning indicator control circuit. The tire pressure warning indicator is connected to the GAUGE fuse. This circuit has power when the ignition switch is in the ON or START positions. When the ignition switch is turned to the ON position, the EBCM turns ON the tire pressure warning indicator for 3�4 seconds for a bulb check. If the EBCM detects a malfunction, the tire pressure warning indicator will stay ON to warn the driver that the tire pressure warning system is disabled and needs service.

Diagnostic Aids
Thoroughly inspect the wiring and the connectors. An incomplete inspection of the wiring and the connectors may result in a misdiagnosis, causing a part replacement with the reappearance of the malfunction.
The following are possible causes of the malfunction:
^ An open or high resistance in the stop lamp signal circuit
^ A short in the stop lamp signal circuit
^ An internal EBCM malfunction

If an intermittent malfunction exists, refer to Testing for Intermittent Conditions and Poor Connections.

Test Description





The numbers below refer to the step numbers on the diagnostic table.
8. This step tests the stop lamp signal circuit for an open, high resistance, or short to ground.
9. This step tests the stop lamp signal circuit for a short to voltage.