SIR Disabling and Enabling Zone 2

SIR DISABLING AND ENABLING ZONE 2

DISABLING PROCEDURE




1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Locate the instrument panel (I/P) fuse box then remove fuse box cover.
5. Locate and remove the F8 fuse.

IMPORTANT: With the F8 fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.




6. Remove the lower center pillar trim.
7. Remove the connector position assurance (CPA) from the seat belt pretensioner - LF connector.
8. Disconnect the seat belt pretensioner - LF connector from the vehicle harness connector.
9. Remove the CPA from the side impact sensor - LF connected.
10. Disconnect the side impact sensor - LF connector.

ENABLING PROCEDURE




1. Remove the key from the ignition switch.
2. Connect the side impact sensor - LF connector and install the CPA.
3. Connect the seat belt pretensioner - LF and install the CPA.
4. Install the lower center pillar.




5. Install the F8 fuse.
6. Install the fuse box cover.
7. Use caution while reaching in and turn the ignition switch to the ON position. The AIR BAG indicator will flash then turn OFF.
8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Testing and Inspection