Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the engine cover bolts and the nuts.
3. Remove the engine cover.




4. Disconnect the camshaft position (CMP) sensor electrical connector.
5. Remove the timing belt front cover.

INSTALLATION PROCEDURE




1. Install the CMP sensor and bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the CMP sensor bolts to 7 N.m (62 lb in).




2. Install the timing bolt front cover.
3. Connect the CMP sensor electrical connector.
4. Install the engine cover.
5. Connect the negative battery cable.