Inflator Module Handling and Scrapping

INFLATOR MODULE HANDLING AND SCRAPPING

AIR BAG MODULE DEPLOYMENT - INSIDE OF VEHICLE

CAUTION: When deploying an airbag inside the vehicle, make sure the vehicle doors are closed and the side windows are fully open. Wear safety glasses throughout the entire procedure. Make sure the deployment area in the vehicle is clear of people, or loose objects. Failure to follow these guidelines could result in personal injury or vehicle damage.

Deploy the air bags before disposing them. If a vehicle is to be scrapped, the air bag may be deployed inside the vehicle.

CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to follow the procedures in the order listed may result in personal injury.

- Before deploying the air bags, remove all loose objects from the air bags expansion area.
- Deploy the air bags with the vehicles doors closed and the side windows open.
- Deploy the air bags only in an evacuated area. Service personnel who must be present during the deployment should be at least 10 m (33 ft) in front of the vehicle.
- Do not connect the voltage source until after having completed all other preparations for the deployment of air bags.
- Allow a deployed air bag module or pretensioner cool for 30 minutes before handling.
- Wear gloves and eye protection during the disposal procedure.
- If the deployment fails, disconnect the voltage source and wait 5 minutes before approaching the vehicle.