Tie Rod: Service and Repair

Rack and Pinion Outer Tie Rod End Replacement

^ Tools Required
- KM-507-C Ball Joint Remover

Removal Procedure





1. Remove the outer tie rod hex nut and disconnect the outer tie rod from the steering knuckle using the KM-507-C .






2. Loosen the tie rod lock nuts and remove the outer tie rod.

Important: Before loosening the tie rod lock nut, mark the position of the lock nut for easy alignment after the installation procedure.


Installation Procedure






1. Install the outer tie rod with the lock nuts.
Tighten the lock nuts to 54 Nm (40 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.






2. Install the outer tie rod with the hex nut.
Tighten the hex nut to 45 Nm (33 ft. lbs.).