Washer Pump/Reservoir Replacement (Typical)

WASHER PUMP/RESERVOIR REPLACEMENT (TYPICAL)

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the front left wheel.
3. Remove the screws and the front wheel well splash shield.




4. Disconnect the washer hoses from the reservoir.
5. Disconnect the reservoir pump electrical connectors.
6. Remove the bolts, the nuts and the reservoir.

INSTALLATION PROCEDURE




1. Install the reservoir with the nuts and the bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the washer fluid reservoir nuts and bolts to 9 N.m (80 lb in).

2. Connect the reservoir pump electrical connectors.
3. Connect the washer hoses to the reservoir.
4. Install the front wheel well splash shield with the screws.

Tighten the front wheel well splash shield screws to 1.5 N.m (13 lb in).

5. Install the front left wheel.
6. Connect the negative battery cable.