B316A

DTC B316A

DIAGNOSTIC INSTRUCTIONS
- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
- Review Strategy Based Diagnosis for an overview of the diagnostic approach.
- Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC DESCRIPTORS

DTC 316A 01
All Windows Control Request Circuit short to battery

DTC 316A 02
All Windows Control Request Circuit short to ground

CIRCUIT/SYSTEM DESCRIPTION
During top operation, the folding top control (FTC) module sends a signal to the window regulators to index the windows open on the retractable hard top request circuits. Upon completion of top operation it sends a signal to close the windows. The FTC monitors the retractable hard top request circuits for proper operation.

CONDITIONS FOR RUNNING THE DTC
The FTC module is active.

CONDITIONS FOR SETTING THE DTC
A short to ground or short to voltage is detected on one or both retractable hard top request circuits.

ACTION TAKEN WHEN THE DTC SETS
The top is disabled.

CONDITIONS FOR CLEARING THE DTC
The fault is no longer present and the top completes one cycle.

DIAGNOSTIC AIDS
An open on either retractable hard top request circuit will cause the windows to be inoperative during top operation.

CIRCUIT/SYSTEM TESTING

B316A 01
1. Disconnect C 1 from the FTC Module.
2. Probe C 1 pin 23 with a test lamp connected to ground. The test lamp should not illuminate.
- If the test lamp illuminates, repair a short to voltage.
3. Probe C 1 pin 11 with a test lamp connected to ground. The test lamp should not illuminate.
- If the test lamp illuminates, repair a short to voltage.
4. If circuits test OK, replace FTC Module.

B316A 02
1. Disconnect C 1 from the FTC Module.
2. Probe C 1 pin 23 with a test lamp connected to B+. The test lamp should not illuminate.
- If the test lamp illuminates, repair a short to ground.
3. Probe C 1 pin 11with a test lamp connected to B+. The test lamp should not illuminate.
- If the test lamp illuminates, repair a short to ground.
4. If circuits test OK, replace FTC Module.

REPAIR INSTRUCTIONS
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Folding Top Control Module Replacement