P1876
DTC P1876
TAP Shift Circuit Performance:
Circuit Description
The transmission adaptive pressure (TAP) Shift system allows the driver to manually shift gears by using the TAP Shift switches located on the Automatic Transmission Shifter. Pushing the Up switch will command an upshift and pushing the Down switch will command a downshift. The TAP Shift system is activated when the gear selector is in the D3 position and is deactivated in all other positions.
If the transmission control module (TCM) detects TAP enable switch Active and the TR switch indicates D4, DTC P1876 sets. DTC P1876 is a type C DTC.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P1876 Up and Down Shift Switch Performance - Range Switch Not in D3
Conditions for Running the DTC
^ No Transmission range switch DTC P0705.
^ No TAP system DTCs P0815, P0816 or P0826.
^ No PSA DTCs P1810, P1816, or P1818.
^ No TAP system performance DTC 1877.
^ No communication DTC U0100.
^ The engine run time is greater than 5 seconds.
Conditions for Setting the DTC
The TCM detects the TAP enable switch is Active and the TR switch is not in D3 for 4 seconds five times during the same trip.
Action Taken When the DTC Sets
^ The TCM does not illuminate the malfunction indicator lamp (MIL).
^ The TCM disables TAP Shift operation.
^ The TCM commands an alternate coast shift pattern where downshifts occur at higher vehicle speeds while coasting.
^ The TCM records the operating conditions when the Conditions for Setting the DTC are met. The TCM stores this information as Failure Records.
^ The TCM stores DTC P1876 in TCM history.
Conditions for Clearing the DTC
^ A scan tool can clear the DTC.
^ The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without a non emission related diagnostic fault occurring.