Front Suspension

Wheel Stud Replacement

Tools Required

J 43631 Ball Joint Remover

Removal Procedure




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove and support the brake caliper and bracket as an assembly, and remove the brake rotor.
4. Rotate the bearing hub to a position where the least amount of interference between the stud and the steering knuckle exists.
5. Using the J 43631, release the wheel stud from the bearing hub and discard the stud.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the NEW stud into the bearing/hub assembly.
Add enough washers (1) in order to draw the stud into the hub.
2. Install and tighten a wheel nut (2) until the head of the wheel stud is fully seated against the back of the bearing hub flange.
3. Remove the wheel nut (2) and the washers (1).
4. Install the brake rotor, and install the brake caliper and bracket as an assembly.
5. Install the tire and wheel assembly.
6. Lower the vehicle.