Operation CHARM: Car repair manuals for everyone.

Oil Pump Replacement



Oil Pump Replacement

Removal Procedure




1. Remove the case side cover.
2. Use a flat-bladed tool to disconnect the electrical connectors from the solenoid valves (315A, 315B, 322, 334 and 440), the TFP manual valve position switch (395) and the temperature sensor (391).





Important: Do NOT remove the bolt (205) that holds the oil pump together.

3. Remove the oil pump bolts (206, 207).




4. Remove the oil pump (200) from the valve body (300).
5. Inspect the oil pump. Refer to Oil Pump Components Assemble in Transmission Unit Repair Manual.

Installation Procedure




1. Install the oil pump (200) to the valve body (300).





Notice: Refer to Fastener Notice.

2. Install the oil pump bolts (206, 207).
^ Tighten the M6 X 1.0 X 85 bolts (207) to 12 N.m (106 lb in).
^ Tighten the M6 X 1.0 X 95 bolts (206) to 16 N.m (12 lb ft).




3. Connect the electrical connectors to the solenoid valves (315A, 315B, 322, 334 and 440), the TFP manual valve position switch (395) and the temperature sensor (391).

Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned. Reset the TAP values. Refer to Transmission Adaptive Functions.

4. Install the case side cover.