Operation CHARM: Car repair manuals for everyone.

Clutch: Service and Repair



Clutch Drive Plate and Clutch Driven Plate

Tools Required

J 29074-A Clutch Alignment Arbor

Removal Procedure

1. Remove the transmission. Refer to Transmission Replacement.




2. Remove the clutch cover bolts one turn at a time, until spring pressure is relieved.




3. Remove the clutch cover and the clutch disc.

Installation Procedure




1. Align the heavy side of the flywheel assembly, stamped with an X, with the clutch cover light side, marked with paint.




2. Install the J 29074-A in order to support the clutch cover to the flywheel assembly.





Notice: Refer to Fastener Notice.

3. Install the clutch cover to flywheel bolts (1, 2, 3, 4, 5, 6).

1. Follow the tightening sequence. Tighten the bolts to 24 N.m (18 lb ft).
2. Tighten the bolts to specifications. Refer to Fastener Tightening Specifications.

4. Remove the J 29074-A.
5. Lubricate the inside diameter of the bearing with GM P/N 12345777, or equivalent.
6. Install the transmission. Refer to Transmission Replacement.
7. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding.
8. Connect the negative battery cable.