Operation CHARM: Car repair manuals for everyone.
Home >> Pontiac >> 2007 >> G6 V6-3.5L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Transmission and Drivetrain >> Relays and Modules - A/T >> Control Module >> Service and Repair >> 6T70/6T75 - Automatic Transmission

6T70/6T75 - Automatic Transmission



CONTROL SOLENOID VALVE AND TRANSMISSION CONTROL MODULE ASSEMBLY REPLACEMENT

Removal Procedure

1. Remove the control valve body cover. Refer to Control Valve Body Cover Replacement. Control Valve Body Cover Replacement




2. Disconnect the input speed sensor electrical connector (1).
3. Disconnect the output speed sensor electrical connector (2).
4. Disconnect the shift position switch electrical connector (3).




5. Remove the control valve body bolts (1) M6 x 80 (Quantity: 4).
6. Position the control solenoid valve spring (8) to the side. Spring will be released with removal of lower control valve body.
7. Remove the control valve body bolts (4) M6 x 65 (Quantity: 2).
8. Remove the control valve body bolt (3) M6 x 42 (Quantity: 1).
9. Remove the control valve body bolts (2) M6 x 95 (Quantity: 3).
10. Remove the control valve body bolt (7) M6 x 55 (Quantity: 1).
11. Remove the upper control solenoid valve body and TCM assembly (5).

Notice: Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter plate to the control solenoid valve assembly, resulting in possible damage or contamination.

12. Remove the control solenoid valve body assembly filter plate (6).

Installation Procedure

Notice: Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter plate to the control solenoid valve assembly, resulting in possible damage or contamination.




1. Install the control solenoid valve assembly filter plate (1).




2. Install the control solenoid valve body and TCM assembly (5).
3. Rotate the control solenoid valve spring (7) into position.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: Install all bolts before tightening, then tighten in specified sequence.

4. Install the control valve body bolts (1) M6 x 80 (Quantity: 4).
5. Install the control valve body bolt (6) M6 x 55 (Quantity: 1).
6. Install the control valve body bolts (2) M6 x 95 (Quantity: 3).
7. Install the control valve body bolt (3) M6 x 42 (Quantity: 1).
8. Install the control valve body bolts (4) M6 x 65 (Quantity: 2).

Tighten the bolts in sequence to 12 Nm (106 lb in).




9. Connect the input speed sensor electrical connector (1).
10. Connect the output speed sensor electrical connector (2).
11. Connect the shift position switch electrical connector (3).
12. Install the control valve body cover. Control Valve Body Cover Replacement
13. For transmission control module programming and setup. Testing and Inspection

Important: After an internal transmission repair or internal part replacement the service fast learn adapt procedure should be performed.

14. Perform the service fast learn adapt procedure. Refer to Service Fast Learn Adapts. Programming and Relearning

pro multis · About Operation CHARM