Folding Top Pump Bracket Replacement

FOLDING TOP PUMP BRACKET REPLACEMENT

REMOVAL PROCEDURE

1. CAUTION:
- Refer to Eye Protection Caution.
- Refer to Folding Top Hydraulic Pressure Caution.
- Refer to Servicing Electrical Components Caution.
Place the folding top in the up position.

2. Open the rear compartment.
3. Disconnect the battery.
4. Place a protective covering over the rear compartment interior and the adjacent body panels.
5. Remove the right side compartment trim.
6. Remove the push-in-pins that attach the control module to the pump bracket.
7. Remove the electrical connectors from the pump bracket and control module.




8. Remove the nuts (2) that attach the pump to the floor pan.
9. Lift the pump upward to disconnect the electrical connector from the hydraulic pump motor.




10. Remove the screws (1) from the pump bracket (2).

INSTALLATION PROCEDURE

1. NOTE: Refer to Fastener Notice.




Install the screws (1) to the hydraulic pump bracket (2).

Tighten the screws to 10 N.m (89 lb in).




2. Connect the electrical connectors to the hydraulic pump.
3. Install the nuts (2) that attach the pump to the floor pan.

Tighten the bolts to 18 N.m (13 lb ft).

4. Connect the folding top pump solenoid harness.
5. Install the electrical connectors to the control module.
6. Install the push-in-pins that attach the control module to the pump bracket.
7. Install the side compartment trim.
8. Remove the protective covering.
9. Connect the battery.
10. Remove the rear compartment lid support.
11. Inspect the hydraulic system fluid level and add fluid as needed.
12. Close the rear compartment.
13. Inspect the folding top for proper operation.