94. Oil Pan Installation

Oil Pan Installation

Tools Required

EN 46109 Guide Pin Set




1. Install the 8 mm (0.315 in) guides from the EN 46109 into the center oil pan rail bolt hole on each side of the engine block.




2. Place a 3 mm (0.118 in) bead (1) of RTV sealant, GM P/N 12378521 (Canadian P/N 88901148) or equivalent, on the block pan rail and the crankshaft rear oil seal housing.




3. Position the oil pan onto the block.




4. Remove the EN 46109 8 mm (0.315 in) guides from the engine block.




5. Loosely install the oil pan bolts.





Notice: Refer to Fastener Notice .

6. Tighten the oil pan bolts in sequence shown.

1. Tighten the 8 mm bolts (1-11) to 23 Nm (17 lb ft).
2. Tighten the 6 mm bolts (12, 13) to 10 Nm (89 lb in).